GPS setting RF front end

????

????Because the LNA in series can provide a 60 dB gain, users can greatly increase the power of the front end of the vector signal analyzer. In our measurement operation, a gain of 60 dB is sufficient to increase the peak power from - 116 dBm to - 56 dBm. With a 60 dB gain (and a 1.5 dB noise figure), the noise power of the signal will be ?? 112 dBm/Hz (- 174+gain+F). Therefore, the SNR can be captured up to 56.5 dB (- 56 dBm+112.5 dBm), which is also lower than the actual dynamic range of the instrument. It can be seen that if there is a dynamic range of 80 dB, the VSA will be able to record the maximum SNR without the noise impact of wireless signals.

????When any wireless signal is to be recorded, the reference level can be set at least 5 dB higher than the normal peak power to cope with any abnormal signal strength. In some cases, although this step will reduce the effective dynamic range of the VSA, the GPS signal will not be affected. Since the maximum ideal SNR of the GPS signal input to the antenna is 58 dB (- 116+174), it is meaningless for VSA to record a dynamic range exceeding 58 dB. Therefore, we can even "discard" the dynamic range of the instrument to more than 10 dB without affecting the quality of the recorded signal (in this bandwidth, PXI-5661 will provide a dynamic range better than 75 dB).

????Since it is necessary to set the appropriate reference level, it is equally important to set the RF front end of the recording device appropriately. As previously mentioned, to obtain the best RF recording data, it is recommended to use an active GPS antenna. Since the active antenna has a built-in LNA that provides a gain of up to 30 dB with a low noise figure, DC bias can also be supplied. A variety of bias modes will be described below.

Read recommendations:

fleet gps tracking supplier

fleet gps tracking manufacturer

NB20 -4G Bluetooth Smart Pet Tracker

GPS, get closer to our lives

GPS vehicle tracking and dispatching function