The main factors that affect the performance of GPS antennas are the following.trailer gps tracker wholesale

????

????1. Ceramic flakes: The quality of ceramic powder and sintering process directly affect its performance. The main ceramic chips currently used on the market are 25 ? 25, 18 ? 18. 15 ? 15. 12 ? 12. The larger the area of the ceramic sheet, the greater the dielectric constant, the higher the resonance frequency, and the better the acceptance effect. Ceramic chips are mostly square in design to ensure consistent resonance in the XY direction and achieve uniform star collection.

????2. Silver layer: The silver layer on the surface of a ceramic antenna can affect the resonance frequency of the antenna. The ideal GPS ceramic chip frequency point is accurately set at 1575.42MHz, but the antenna frequency point is very susceptible to the influence of the surrounding environment, especially when assembled in the entire machine. It is necessary to adjust the silver coating shape to maintain the frequency point at 1575.42MHz again. Therefore, GPS equipment manufacturers must cooperate with antenna manufacturers when purchasing antennas and provide complete machine samples for testing.

????3. Feed point: The ceramic antenna collects resonance signals through the feed point and sends them to the backend. Due to antenna impedance matching, the feed point is generally not in the center of the antenna, but slightly adjusted in the XY direction. This impedance matching method is simple and does not increase the cost. Moving only in the single axis direction is called a single biased antenna, and moving on both axes is called a double biased antenna.

????4. Amplification circuit: The shape and area of the PCB carrying the ceramic antenna. Due to the characteristic of ground bounce in GPS, when the background is 7cm ? When the ground is 7cm uninterrupted, the efficiency of the patch antenna can be maximized. Although constrained by factors such as appearance and structure, try to maintain a considerable area and uniform shape. The selection of amplification circuit gain must be coordinated with the backend LNA gain. The GSC3F of Sirf requires that the total gain before signal input should not exceed 29dB, otherwise the signal Supersaturation will generate self excitation.

????GPS antenna has four important parameters: Gain, VSWR, Noise figure, and Axial ratio. Among them, special emphasis is placed on the shaft ratio, which is an important indicator to measure the difference in signal gain of the entire machine in different directions. Due to the random distribution of satellites in the hemisphere sky, it is crucial to ensure that the antenna has similar sensitivity in all directions. The axial ratio is affected by antenna performance, external structure, internal circuit of the entire machine, and EMI.

Read recommendations:

Car gps tracking Manufacturing

gps vehicle tracker Processing

NB20 -4G Bluetooth Smart Pet Tracker

GPS Application Solution

GPS forward direction (heading).gps tracker for bike wholesale