The following aspects mainly affect the performance of GPS antenna

????

????1. Ceramic chip: the quality of ceramic powder and sintering process directly affect its performance. The ceramic chips currently used in the market are mainly 25 ? 25??18 ? 18??15 ? 15??12 ? 12?? The larger the area of ceramic sheet, the larger the dielectric constant, the higher the resonance frequency, and the better the acceptance effect. Most of the ceramic chips are square in design to ensure that the resonance in the XY direction is basically consistent, so as to achieve the effect of uniform star collection.

????2. Silver layer: The silver layer on the surface of ceramic antenna can affect the resonant frequency of antenna. The ideal frequency point of GPS ceramic chip is accurate at 1575.42MHz, but the antenna frequency point is very vulnerable to the surrounding environment. Especially when it is assembled in the whole machine, the frequency point must be adjusted to maintain 1575.42MHz again by adjusting the shape of the silver coating. Therefore, when purchasing antenna, the manufacturer of GPS complete machine must cooperate with the antenna manufacturer to provide complete machine samples for testing.

????3. Feed point: the ceramic antenna collects the resonance signal through the feed point and sends it to the rear end. Because of antenna impedance matching, the feed point is generally not in the center of the antenna, but slightly adjusted in the XY direction. This impedance matching method is simple and does not increase the cost. Moving only in the single axis direction is called monopolarized antenna, and moving in both axes is called bipolarized antenna.

????4. Amplification circuit: shape and area of PCB carrying ceramic antenna. Because GPS has the characteristic of touchdown rebound, when the background is 7cm ? When the ground is 7cm, the patch antenna can play its best role. Although restricted by such factors as appearance and structure, try to maintain a considerable area and uniform shape. The gain of the amplifier circuit must be selected in conjunction with the rear LNA gain. The GSC3F of Sirf requires that the total gain before signal input shall not exceed 29dB, otherwise signal over saturation will cause self excitation.

????The GPS antenna has four important parameters: Gain, VSWR, Noise figure, and Axial ratio. The axle ratio is especially emphasized, which is an important indicator to measure the signal gain difference of the whole machine in different directions. Since satellites are randomly distributed in the hemisphere sky, it is very important to ensure that the antenna has similar sensitivity in all directions. The axial ratio is affected by antenna performance, external structure, internal circuit of the whole machine and EMI.

Read recommendations:

Gps speed limiter equipment

Pet GPS Tracker sales

G03

GPS Snitch real-time target tracking

gps tracker to solve financial risk problem?